 | |  | |  | |  | |  | |  | |  |
The "DELTA Probe" TM gives you a reliable, temporary, mechanically non-invasive way to make contact with the legs of most TSOP,
TQFP, or PQFP integrated circuits having leg spacings of 0.5mm, 0.635mm, 0.65mm, & 0.8mm. The special design and patented
materials of the "wedge" shaped conductors allow them to be inserted tightly between all of the I.C. legs at once without damaging
them, saving you time and money. Contact is made on both sides of each leg by gold plated, redundant, BeCu contacts for a very low
resistance (<1.0 ohm) and capacitance (<1.5 pf) signal path back to your test cable. All of this is accomplished within the footprint of
the I.C. eliminating large keep-out areas or special hard test points and / or connectors that were previously required.
Accessories include breakout Crossflex Cables with dual inline male pins that accept standard 0.10" grid female ribbon cable connectors,
extender Flex Cables to move the signals away from the I.C., and male by male pin Double Header PCBA’s available in 0.018" x 0.018" x
0.12" long or 0.018" x 0.030" x 0.12" long pins that provide the connection between the female output sockets on the probe and female
sockets on the flex cables, flying leads of a Logic Analyzer, or a microprocessor / emulator board, etc.
TQFP, or PQFP integrated circuits having leg spacings of 0.5mm, 0.635mm, 0.65mm, & 0.8mm. The special design and patented
materials of the "wedge" shaped conductors allow them to be inserted tightly between all of the I.C. legs at once without damaging
them, saving you time and money. Contact is made on both sides of each leg by gold plated, redundant, BeCu contacts for a very low
resistance (<1.0 ohm) and capacitance (<1.5 pf) signal path back to your test cable. All of this is accomplished within the footprint of
the I.C. eliminating large keep-out areas or special hard test points and / or connectors that were previously required.
Accessories include breakout Crossflex Cables with dual inline male pins that accept standard 0.10" grid female ribbon cable connectors,
extender Flex Cables to move the signals away from the I.C., and male by male pin Double Header PCBA’s available in 0.018" x 0.018" x
0.12" long or 0.018" x 0.030" x 0.12" long pins that provide the connection between the female output sockets on the probe and female
sockets on the flex cables, flying leads of a Logic Analyzer, or a microprocessor / emulator board, etc.
Colorado Springs, Colorado
Home
QFP TEST CLIPS
ADVANCED SMT TEST PROBES
ADVANCED SMT TEST PROBES